Weima Electric (Shanghai) Ltd.

• Compact, highly reliable and fully self-contained design.

• Robust casing design.

• 11 frame sizes covering a shaft diameter range of 280-1000mm.

• Radial loads are supported on a spherically seated whitemetal lined journal bush which is supplied in halves.

• High pressure oil injection can be incorporated in the journal bush if required.

• Tilting whitemetal thrust pads or whitemetal location faces can be incorporated at each end of the journal bush to support axial loads.

• Design can include offset pivoted tilting thrust pads in order to reduce oil film temperatures and maximise film thicknesses.

• Centre pivoted thrust pads can be fitted when continuous bi-directional operation is a requirement.

• High pressure oil injection can be incorporated in the thrust faces if required.

• PTFE thrust pads can be incorporated in the thrust faces to increase the thrust capacity and reduce the bearing frame size.

• Oil circulation is achieved using an oil ring which is supplied in halves and clamped to the shaft working in conjunction with a floating oil scraper in the casing top.

• Available with water cooling, circulating oil cooling or fan / air cooling.

• Integral cooler assemblies can be supplied in cupro-nickel, stainless steel or titanium.

• Electrical insulation can be provided.

• Labyrinth end baffles, which are supplied in halves, are included at each end of the bearing.

• Sealing to various IP grades can be provided at each end of the bearing as required.

• Easy to install and maintain.

• Design can accommodate a wide variety of instrumentation requirements.

  
  

Notes 

Location load shown corresponds to the maximum shaft diameter within each frame size. Higher loads are possible for smaller diameter shafts. 

Operating speeds 

IH Series bearings will generally operate water cooled for shaft linear speeds of up to 25m/s. Using circulating oil cooling, shaft speeds of up to 34m/s may be acheived.